Using IEEE802.1X (Wired LAN)

This machine is compatible with IEEE802.1X authentication. IEEE802.1X authentication is possible after IEEE802.1X authentication on the web page of this machine is enabled and the authentication switch is connected.


Setting with EAP-TLS

This section describes how to set up EAP-TLS, one of the IEEE802.1X authentication.

  1. Open the web page of this machine.

    Opening the web page

  2. Log in as an administrator.

    Logging in as an administrator
  3. Select [Admin Setup].
  4. Select [Network] - [IEEE802.1X].
  5. Select [Enable] in [IEEE802.1X].
  6. Select [EAP-TLS] in [EAP Type].
  7. Input the user name in [EAP User].
  8. Select [Not use SSL/TLS Certificate for EAP authentication], and click [Import].
  9. Input the file name of the certificate.
    Only PKCS#12 files can be imported.
  10. Input the certificate password, and click [OK].
  11. Select [Authenticate Server], and click [Import].
  12. Input the file name of the CA certificate, and click [OK].
    Specify the CA certificate used for RADIUS server authentication. PEM, DER and PKCS#7 files can be imported.
  13. Click [Submit].
    The new settings will take effect after the network function of the machine has been reset.
  14. When the machine is online, power off the machine.
  15. Remove the LAN cable from the machine.
  16. Go to "Connecting this machine to the authentication switch".


Setting with PEAP

This section describes how to set up PEAP, one of the IEEE802.1X authentication.

  1. Open the web page of this machine.

    Opening the web page

  2. Log in as an administrator.

    Logging in as an administrator
  3. Select [Admin Setup].
  4. Select [Network] - [IEEE802.1X].
  5. Select [Enable] in [IEEE802.1X].
  6. Select [PEAP] in [EAP Type].
  7. Input the user name in [EAP User].
  8. Input the password in [EAP Password].
  9. Select [Authenticate Server], and click [Import].
  10. Input the file name of the CA certificate, and click [OK].
    Specify the CA certificate used for RADIUS server authentication. PEM, DER and PKCS#7 files can be imported.
  11. Click [Submit].
    The new settings will take effect after the network function of the machine has been reset.
  12. When the machine is online, power off the machine.
  13. Remove the LAN cable from the machine.
  14. Go to "Connecting this machine to the authentication switch".


Connecting this machine to the authentication switch
  1. Check that this machine is powered off.
  2. Connect the LAN cable to the network interface connector of this machine.
  3. Connect the other end of the LAN cable to the authentication port of the authentication switch.
  4. Power on this machine.
  5. Set the IP address of this machine.