6. Checking the connection from a PC

  1. Press the scroll button ▼ on the operator panel several times to select [Configuration], and then press «ENTER».

  2. Press ▼ several times to select [Network], and then press «ENTER».

  3. Press ▼ to select [Wireless (Infrastructure) Information], and then press «ENTER».

  4. Press ▼ several times to select [IPv4 Address], and then press «ENTER».

  5. Take a note of the displayed IP address.
  6. Start the web browser in your PC.

  7. Input "https://(the IP address recorded in Step 5)", and press the «Enter» key.
    Connection is successful when the web page of this machine is displayed.

    • If the web page of this machine is not displayed, the network connection between the PC or other terminals and this machine has failed.
      Check if [IP Address Set], [IPv4 Address], [Subnet Mask] and [Gateway Address] of this machine are set correctly.

    • By default, when you are opening the machine's web page, use HTTPS instead of HTTP.
    • By default, when you are opening the machine's web page, a warning that it may not be a legitimate server will be displayed in your web browser. Set up the certificate appropriately, or temporarily ignore the warning.

    • If you cannot access the machine via HTTPS due to an expired certificate or a corrupted certificate, set [HTTPS Redirection (Web)] to [Disable] from the operator panel, access the web page via HTTP, and reset the HTTPS settings.

    • This machine does not support TLS 1.1 or lower. If the web browser you are using only supports TLS 1.1 or lower, use a web browser that supports TLS 1.2 or higher, or after understanding the security risks, set [HTTPS Redirection (Web)] to [Disable] from the operator panel and access the web page via HTTP.

Then, go to "Installing software on your PC".

When using a mobile device, go to "Printing from a mobile device".