Replacing image drums
This section explains how to replace the image drum only and continue using the existing toner cartridge.
![]()
If you attach the existing toner cartridge to a new image drum, the remaining amount of the toner cartridge may not be displayed correctly. In addition, "[Color Name] Toner Low." or "[Color Name] Toner Empty. Waste Toner Full." may be displayed after the replacement.
Handle with adequate care since (the green tube of) the image drum is very easy to be damaged.
Do not expose the image drum to direct sunlight or strong light (approx. 1,500 lux or above). Do not leave it uncovered for more than 5 minutes even under room lighting.
Please use genuine OKI consumables for optimum performance.
Failures caused by using non-genuine consumables may void the warranty or maintenance contract. (The use of non-genuine consumables will not necessarily cause failures, but please fully take notice of such usage.)
![]()
The timing of displaying the "[Color Name] Image Drum Near Life." message can be changed. Configure the setting from [Admin Setup] - [Others Setup] - [Near Life Setup] - [Drum Near Life Timing] on the operator panel. The possible range is 500 - 5,000 (in increments of 500).
Prepare a new image drum.
Insert your finger into the recess on the right side of this machine, pull the front cover open lever (1), and open the front cover (2) towards you.

Press the open button (3) to open the output tray (4).

Otherwise, burns may be caused. 
Do not touch the fuser unit because it is hot.

Check the image drum to be replaced by the label color.

Remove the image drum (5) from the machine, and then place it on a flat surface covered with newspaper or the like.

- Handle with adequate care since (the green tube of) the image drum is very easy to be damaged.

While pressing the toner cartridge, turn the tip of the blue lever (6) until it aligns with the front ▲ mark.

Lift the right side of the toner cartridge (7), and remove the toner cartridge from the image drum.

Remove the new image drum from its packaging, and then place it on a flat surface covered with newspaper or the like.
Remove the dessicant and protective sheet.

- Remove the toner cover.

Fit the recess (8) on the left side of the toner cartridge (7) removed in Step 7 onto the protrusion (9) on the image drum, and align the toner cartridge with the color label of the image drum. Then, gently lower the right side.

While pressing down on the toner cartridge, turn the tip of the toner cartridge lock lever (6) (blue) until it aligns with the rear ▲ mark to secure the toner cartridge to the image drum.
You will hear a "click" when it locks into place.

Confirm the color of the new image drum, and install it into the device.

- Handle with adequate care since (the green tube of) the image drum is very easy to be damaged.

Firmly press the center of the output tray (4) to close it.

Close the front cover (2).

- The front cover cannot be closed if the output tray is not securely closed.

![]()
- Please recycle the used image drum.
