|
Cause
|
Solution
|
Reference
|
|
The network connection setting is incorrect.
|
-
[Wireless(Infrastructure)] and [Wireless(AP Mode)] cannot be enabled at the same time.
-
To connect using [Wireless(Infrastructure)], set [Wireless(AP Mode)] to [Disable], and then set [Wireless(Infrastructure)] to [Enable].
-
To connect using [Wireless(AP Mode)], set [Wireless(Infrastructure)] to [Disable], and then set [Wireless(AP Mode)] to [Enable].
|
Connecting This Machine to a Network
|
|
[Wireless(Infrastructure)] Not connected to a wireless access point. (If wireless LAN module is fitted)
|
-
Check that the wireless access point power is switched on.
-
Check the wireless access point settings, and then try the manual settings or automatic settings.
-
Restart the wireless LAN function.
-
Press [Device Settings], select [Admin Setup] > [Network Menu] > [Network Setup] > [Wireless Setting], and then select [Wireless reconnection].
-
Install this machine in a place with a good view and near a wireless access point. (We suggest that the distance between the machine and the access point be 30 m or less.)
If there is metal, aluminum sash, or a reinforced concrete wall between the machine and wireless access points, connections may be harder to be established.
Do not place any electric appliances that emit weak radio waves (such as microwaves or digital cordless telephones) close to the machine.
|
Connecting This Machine to a Network
|
|
[Wireless(AP Mode)] No wireless devices (computers, tablets, smartphones) are connected.
|
-
Make sure that [Wireless(AP Mode)] on the machine is set to [Enable].
-
Confirm the SSID/password for the machine and try Manual Setup.
-
Make a setting in a location near the machine with good visibility.
-
Up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected. Disconnect at least one device and try again.
|
Connecting This Machine to a Network
|
