Setting TAD Mode

Set an operation type in Ans/Fax Ready mode.

  1. Press the (SETTING) button on the operator panel.

  2. Press the button once to select [Admin Setup] and press the button.

  3. Enter the administrator password, and then press the (OK) button.

    Memo

    The factory default administrator password is "999999". If the administrator password is changed, enter the updated password.

  4. Press the button to select [Fax Setup] and press the button.

  5. Press the or button to select [Fax Setting] and press the button.

  6. Press the or button repeatedly to select [TAD Mode] and press the button.

  7. Press the or button to select TAD mode type, and then press the (OK) button.

    • [Type 1]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the fax reception starts automatically.

      When the answering machine finishes responding, the fax reception starts.

      If there is a problem with a fax reception, using this type may improve the problem.

    • [Type 2]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.

      Even after the answering machine finishes responding, the fax reception does not start.

      If you usually receive calls, use this type.

    • [Type 3]: Fax signal detection starts in 15 seconds after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.

      When the answering machine finishes responding, the fax reception starts.

      Use this type for normal use.

  8. Press the button until the home screen is displayed.