There are two types of automatic transmissions: Memory transmission which allows you to start sending a fax after the document is scanned, and Real time transmission which allows you to send a fax while the document is being scanned.
-
Memory transmission
Memory transmission is a method to send a fax after the document is scanned in the memory of this machine. You can take the document out without having to wait until the transmission is complete, saving your time.
-
Real time transmission
Real time transmission is a method to send a fax directly to the recipient without scanning the document in the memory of this machine. The transmission starts immediately after you complete transmission operation, allowing you to check that the data is sent to the recipient.
[Memory Tx] is set by factory default.
To enable real time transmission, follow the procedure below.
Note
-
If using the document glass with real time transmission, only one page can be scanned.
-
You cannot perform an operation that uses the ADF or document glass while a fax is being sent with real time transmission.
-
Press the
(FAX) button on the operator panel. -
Set a document in the ADF or on the document glass.
-
Check that [Fax] is selected, and then press the
button. -
Press the
button to select [Fax Functions] and press the button. -
Press the
or button repeatedly to select [Memory Tx] and press the button. -
Press the
or button to select [OFF] and press the 
(OK) button. -
Press the
button to go back to the standby screen. -
Change other settings if necessary, and then press the
(MONO) button.