Adjusting the Density (Density)

You can adjust the scan density in seven levels.

  1. Press the (FAX) button on the operator panel.

  2. Set a document in the ADF or on the document glass.

  3. Check that [Fax] is selected, and then press the button.

  4. Press the button to select [Fax Functions] and press the button.

  5. Press the or button to select [Density] and press the button.

  6. Press the or button to select the density, and then press the (OK) button.

    Memo

    [0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or [-3] (lightest).

  7. Press the button until the start screen is displayed.

  8. Specify a destination.

    Entering Fax Number to Send a Fax

    Specifying a Destination from Phone Book

    Specifying a Destination Using One-touch Button

    Specifying a Destination from Transmission History and Reception History

  9. Change other settings if necessary, and then press the (MONO) button.

Topics

You can change other settings for fax transmissions.

Setting Scanning for Transmission

Entering Fax Number to Send a Fax