Forwarding Print Jobs to a Registered Device

This section describes how to forward selected print jobs to a registered device using the OKI LPR Utility. This section also describes how to automatically forward a print job to a different registered device when a problem occurs on the forward destination device.

Note

  • Print jobs can only be forwarded to a device of the same model as your device.

  • Before forwarding a job, you must add a device.

Forwarding the Selected Print Jobs

  1. Start OKI LPR Utility.

  2. Select [Job Status] from the [Remote Print] menu.

  3. To forward a print job, select a job, select [Redirect] from the [Job] menu, and then select the destination device.

Forwarding Print Jobs Automatically

If you are unable to print because the selected device is busy, offline, out of paper, or due to other reasons, you can set so that a print job can be automatically forwarded to another OKI model device.

Note

You must log in as the administrator.

  1. Start OKI LPR Utility.

  2. Select the device to set.

  3. Select [Confirm Connections] from the [Remote Print] menu.

  4. Click [Details].

  5. Select the [Automatic Job Redirect Used] check box.

  6. To forward jobs only if an error occurs, select the [Redirect only at the time of an error] check box.

  7. Click [Add].

  8. Enter the forwarding destination IP address, and then click [OK].

  9. Click [OK].