This section describes how to add or delete destination computers for Scan To Computer when the machine is connected via network.
Memo
The computer with the scanner driver installed is registered to the device when it was installed.
-
Press [Device Settings] on the touch panel.
-
Press
or
several times to select [Network Scan Destination].
-
Press [Register] of a registration location.
To edit a registered computer name, select [Edit].
-
Enter a destination in [Destination].
-
Enter a destination.
You can enter up to 16 characters.
-
Press [OK].
-
Press [Destination Address].
-
Enter an IP address, host name, or computer name.
You can enter up to 64 characters.
-
Press [OK].
-
Press [Port No.].
-
Enter a port number, and then press [OK].
-
Press [Close] on a confirmation screen.
-
Press [Back] until the home screen is displayed.