Unpacking and Installing the Machine

This section describes how to unpack and install the machine.

Injury may result.

Lift this machine by 3 persons, because it weighs approximately 64 kg.

Note

  • Use extra care when handling the image drum (the green cylinder), because it is fragile.

  • Do not expose the image drum to direct sunlight or strong light (approximately 1,500 lux or more). Even under room lighting, do not leave the image drum for 5 minutes or more.

  • Packaging and cushioning material is required for transporting the machine. Do not dispose of it, and keep it for future use.

  1. Remove the machine from the box, and then remove cushioning material and the plastic bag from the machine.

    A set of accessories is packed within the cushioning material.

  2. Lift the machine, and then place it where it is to be installed.

    Note

    Do not open the scanner unit until step 6.

  3. Take the accessories out.

  4. Remove the cushioning materials and protection tapes.

  5. Remove the protection tapes.

  6. Hold the handle (A) to open the scanner unit.

  7. Remove the desiccant pack and protective sheet attached to the transparent part.

  8. Remove the protective sheet.

  9. Insert your finger into the recess (B) on the right side of the machine and pull the front cover open lever (1) to open the front cover (2) forward.

    Note

    Open the front cover gently. If opening rapidly, an MP tray may open.

  10. Press the button (C) and open the Output Tray (3).

  11. Take all four image drums out.

    Note

    • Do not expose the image drum to light for 5 minutes or more.

    • Do not touch the shiny green surface at the bottom of the image drum.

  12. Remove the protective sheets from four image drums.

    1. Place an image drum on a newspaper.

      Remove a tape stuck on a protective sheet and open it.

    2. Pull out a protective sheet in the direction of the arrow.

    Note

    Do not turn the blue lever of the toner cartridge.

  13. Put all four image drums back into the machine.

  14. Turn the blue lever of the toner cartridge backward until its top aligns on the mark.

    Turn the levers of all 4 toner cartridges.

  15. Close the output tray.

  16. Close the front cover.

    Note

    • The front cover cannot be closed securely if the output tray is not closed.

    • When the error message that the output tray or front cover is open does not disappear from the operator panel's display screen, make sure they are closed securely.

  17. Hold the handle (A) to close the scanner unit.