Set an operation type in Ans/Fax Ready mode.
-
Press [Device Settings] on the touch panel.
-
Press or several times and press [Admin Setup].
-
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "aaaaaa" respectively.
-
Press [Fax Setup].
-
Press [Fax Setting].
-
Press or several times and press [TAD Mode].
-
Select a type.
-
[Type 1]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the fax reception starts automatically.
When the answering machine finishes responding, the fax reception starts.
If there is a problem with a fax reception, using this type may improve the problem.
-
[Type 2]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.
Even after the answering machine finishes responding, the fax reception does not start.
If you usually receive calls, use this type.
-
[Type 3]: Fax signal detection starts in 15 seconds after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.
When the answering machine finishes responding, the fax reception starts.
Use this type for normal use.
-
-
Press [Back] until the home screen is displayed.